1) Locate the height and position of the electronic whiteboard to be installed, and mark the holes position of the wall-mounting pieces on the wall as shown in the picture below.
2) Drill holes in the four marked spots with a diameter of 8mm drill and fix the wall pieces by using 6*70 expansion screws.
3) Fix the two pieces of supports onto the lower frame of the back of whiteboard, as shown below.
4) Fix the Link button into the wall pieces, see attached picture above.
5) Mark the position of holes in the Support after successfully hanging the whiteboard on the wall, lay flat the whiteboard on the package carton, drill holes in the marked two spots with a diameter of 8mm drill and fix the support by using 6*70 expansion screws.
1) The connection of the whiteboard to the computer needs only one USB data cable, without an external power supply. After the whiteboard is fixed on the wall, find the USB interface in the right corner of the lower whiteboard frame, plug the USB cord into the USB slot (See picture 2-1).
2) Fix the USB cable with the cable clip on the back of the whiteboard so as to ensure the stable connection of the USB plug to the USB slot. (See Figure 2-2).
3) Connect the other end of the USB plug into the spare USB slot of the computer.
Picture: 2-1
Picture: 2-2
! Caution
1. Avoid placing Labwe interactive electronic whiteboard in a dusty, smoky environment or in high temperature setting
2. Avoid placing the cables on the floor so as to prevent tripping. If you have to, straighten the cable and fix it up with insulating tape in a warning color or with wire casing.
Connect video input (VGA IN) of projector to video card VGA interface of the computer.
After proper connection of the projector to the PC, position the lighting bulb of the projector to the horizontal center of the board surface (c.f. the blue line as indicated below).
Power on the projector, adjust it and ensure that it projects onto the effective area of the whiteboard ( Effective area is 10mm to the border of whiteboard frame), and that the projected area is centrally located on the whiteboard. Finally, adjust the keystone of the projector to make the projected area square.
! Caution
1.If the projector is not properly positioned to the interactive whiteboard or the projected area is not regularly adjusted, the calibration may not be precise.
2.The projected area should be within the effective area of the interactive whiteboard. Otherwise, the interactive whiteboard may not work properly.